About sleeperwaking

Jack of all trades, master of none. There's just too many different things to try and so little time!

Cthulhu Dice Bag a.k.a. Project Pincushion

My friend Peter had a birthday last week, and in honour of this occasion (and the fact that he loves the works of H.P. Lovecraft) I decided to knit him a Cthulhu Dice Bag, pattern by A.A. Leavitt-Reynolds.

This was called “Project Pincushion” as to finish it in time I had to knit in the presence of the intended recipient, who naturally asked what I was knitting. My inspired answer was as follows: “Erm… a really small cushion… for sticking pins in… A pincushion! Yes, that’s what I’m making.” *facepalm*

I decided to be unoriginal and stick to the black and luminous green colour scheme, using 100% acrylic DK yarn and 4mm needles (straight and circular). The first stage is to knit a moss stitch square for the base. I cast on 18 stitches instead of 15 to get a squarer bag – the pattern later asks you to pick up 70 stitches, and 70/4 = 17.5. Therefore I felt that a stitch count of 18-17-18-17 would make a slightly more regular bag than 15-20-15-20.

DSCF5713

The above photo shows my first attempt at picking up stitches off the completed square. I did manage to use just a knitting needle to begin with, but I switched to using a crochet hook later on.

Then I knit a few rows before starting the stranded knitting chart (also known as fair isle, but I’m calling it stranded knitting here as the pattern definitely is NOT fair isle in the slightest). This was my first attempt at stranded knitting, and I was a bit nervous after reading lots of dire warnings about keeping the floats loose. As one tutorial said to always pick up the next colour from underneath the current colour, I ended up knitting the live yarn continental style whilst holding the non-live (dead?!) yarn out of the way in my right hand. This is also first time I’ve attempted to knit continental style as well – there’s a lot of firsts in this project! I got into the habit of it after a while, using this tutorial to learn how to wrap yarns over long stretches. After a while, Cthulhu began to emerge from the depths…

DSCF5717

Constantly swapping between the two yarns resulted in a tangled mess as they wrapped around each other. I had to untangle this every half round or so, easy enough as it just involved suspending the project from the tangle and watching it unspin.

DSCF5718

DSCF5719

Eventually it was finished and I knit a 16″ long piece of I-Cord to finish it off. The pattern asks for 20″, but as I used DK yarn throughout instead of aran weight, the shorter length was more than enough. So here is the finished bag inside out showing the floats:

DSCF5728

Right side out:

DSCF5730

DSCF5732

All that was left was to fill it with some dice and give it to the birthday boy! Fortunately, the people at Q workshop do a good line in H.P. Lovecraft themed dice.

DSCF5734

DSCF5735

It went down well with Peter, so I’m counting that as a success! Some of the Cthulhus look a little deranged (there’s one which is a bit lopsided, and another with massive black eyes) but Cthulhu is a monstrous Elder God the mere thought of whom can send people insane, so I reckon a bit of deranged-ness is quite appropriate. Not so easy to shrug off is the I-Cord. I did it in a hurry and there were some random half-loops sticking out the sides. I’m not sure if that’s where I’ve split the yarn, or where I wasn’t knitting tightly enough. The pattern also called for a crochet edging which I didn’t have time to do. I’m telling myself it would have been OTT to have crochet edging as well though…

Greenleaf Baby Hat

As previously mentioned, I made a hat to go with the sprout blanket. I chose the Greenleaf Baby Hat pattern by Evelyn Uyemura due to the leaf motif. The parents told me that they have lots of hats but most of them are too large so, using the same yarn as the blanket, I followed the instructions at the end of the pattern for the smaller size using a 4mm needle.

I don’t own any 4mm double pointed needles, and only have one 4mm circular needle, so I used the magic loop method to knit in the round with that one circular.

In the end, it looked something like this:

DSCF5437

DSCF5452

DSCF5453

It’s a very pretty hat and I managed to finish it in a weekend which is a record. Unfortunately, it was a bit too small after all that! So last week I made a Hat Mk II, casting on with 8 more stitches but still using 4mm needles and trying to “knit loose”. This time it was a success, confirmed to me with (extremely cute!) visual evidence of baby in said hat. Yay!

So this counts as several first for me: First time knitting in the round, first time using the magic loop, and first time making I-cord! The only problem I found with the magic loop method was that the the first stitch you make on each “half” pulls the last stitch of the previous “half” tighter around the cable, so it’s no longer the same size as your needles. On Hat Mk I this left two slightly odd looking columns of stitches (one for each half), but I think it was better for Hat Mk II.

IMechE Railway Challenge

So one reason for my lack of posts recently was due to the IMechE Railway Challenge, held at the Stapleford Miniature Railway. The challenge is to build a 10 1/4″ gauge locomotive capable of pulling a 600kg load, and they’re scored based on the ride quality, traction power and regenerative energy capability. It’s based on Formula Student, but aimed at creating interest in the railways once again, rather than cars which have a lot of enthusiasts already.

One of my colleagues at work wanted to enter as an independent team, and my friend Phil, myself and the lovely Rob (my boyfriend) said we’d help him out a bit. Unfortunately, a lot of the helping out happened over the last 5 weeks. Seeing as the Challenge itself was four days ago, and the build started in earnest about 3 weeks before then, needless to say the first time our locomotive was fully assembled was at the challenge site. Also, due to the complete lack of testing (what with it not existing until the day before), we didn’t do very well and came 4th (out of 4).

On the positive side, we did build a locomotive which moved under its own power (and stopped under its own power using “active braking”, although there was no parking brake or indeed friction brakes at all). We did this in a VERY short time, using freely available hand tools, and spent under £2000. Don’t believe me? Have some video evidence:

Morning Star moves! This was about 5 minutes before we were due to compete, and Rob had just spent a frantic couple of hours replacing and rejigging the electronics after they got burnt out during testing. The sharp rattling sound near the end is the chain falling off the drivegear – our suspension is far too soft so the gap between the two sprockets can (and did) decrease, resulting in a lost chain. However, a week before our suspension was far too hard, and they would not have let us compete. Swings and roundabouts.

Fifteen minutes after the video was taken (the judges needed some extra time to set things up) we attempted to compete, and the electronics blew up after pulling the 600kg load 10 metres. Still, it’s better than the 1 metre we managed the previous day. As I maintain, it is a 1000% improvement!

Anyway, life got put on hold on the run up to the Challenge. Rob and I are just starting to get things back on track as the house is a tip, and the garden has become a jungle! I dread going back out there to tackle the weeds and the lawn. :(

Growth of an Allium

*must post must post must post*

Ok, have a few photos showing the growth of a type of Allium (Purple Sensation) I planted as a bulb last autumn:

DSCF4985

The swizzle-y leaf protruding in from the left is from a Honey Lily. If I do a follow-up “growth” post, it’ll be on that. :)

DSCF5222

DSCF5286

DSCF5298

DSCF5386

Currently all the purple petals have fallen off and all the leaves have died back, leaving behind these explosion shaped seed heads on 2-3 foot high stalks. Pretty damn cool! Seeing as these have survived, I’m planning to plant some different allium varieties this Autumn as well.

Next post, if I’ve persuaded my friend to upload the videos, I’ll show you what’s been distracting me from the blog over the past month or so. Otherwise, it’s a toss up between the honey lily and the baby hat.

Finally finished!

I kinda went on a hiatus there didn’t I? I blame the clocks going forward, I really do. More daylight hours in the evenings = more time outside gardening, and therefore less time on the blog. I also must admit that various Steam Sales had something to do with it (I can’t find an apt link, so you either know what that means or you don’t – it involves my new PC, the internet and games).

Anyway, the sprout blanket is finally knitted, ends sewn in, washed, blocked and labelled up to go to the recipient, who is now nearly a month old (oops). I got everything together last Friday to finish it off.

Yarn review: The yarn (Patons Cotton Twist Aran) was quite pleasant to use. The resulting blanket is soft and drapey, and the acrylic nicely tames any harshness from the cotton. However, it is a “Z” twist yarn, which according to Doris Chan is better suited for crochet than knitting and I believe her. Basically, yarn is either “S” twist or “Z” twist (to find this out, hold the yarn vertically and see which letter the twist represents). “S” twist yarns have the twist reinforced during knitting, and get unravelled during crochet. “Z”s are the other way round. Therefore I found that the yarn became a bit easy to split with the needle tip, but I reckon if I crochet with it it’ll be fine.

Pattern review: The pattern was easy to follow and not that difficult knitting-wise. My only complaint is the use of pfbs, as these leave a larger loop on the right side of the fabric which to me looks untidy (even when there’s a nice pattern of larger loops). I did make a mistake here or there, the most noticeable of which left a hole in the stem of the central sprout. Oh well. Have some photos!

DSCF5187

DSCF5188

Starting off using the long tail cast on. I really like this cast on (was my first time using it). You get a neat edge and it’s very quick to do once you get used to it.

DSCF5299

DSCF5300

Adventures in frogging. I noticed I’d made a mistake when I suddenly had the wrong number of stitches and the pattern no longer fit. I tried to fix it from the current row, but it just made it worse so I got a contrasting yarn and threaded it into every stitch of the last correct wrong side row. I chose to go back to a wrong side row as the stitches used were either purl or knit, nothing fancy to think about. The second picture shows the yarn going underneath the right hand “leg” of the stitches.

DSCF5303

DSCF5304

DSCF5305

Success! The first photo shows one of the sprout tips correctly hung on the lifeline. I was so, so, SO relieved by that. I spent ages trying to work out just which bit was the right hand leg of all those stitches. Patience and logic is definitely the key to success there. I might do some sort of tutorial when I get some time (and can remember what it is I did).

The second photo shows threading the needle back through the loops, following the lifeline (and putting the stitch markers back on when prompted by the yarn ends). And then voila! Back on the needles! Woohoo!

DSCF5432

DSCF5435

DSCF5431

And there we go, one finished blanket, all ready to go to one baby girl. :) I used a sewn bind off to match the long tail cast on. It’s a reasonable approximation, not exact, but you’d only notice if you look very closely (and that’s probably more to my lack of skill than anything).

To go with the blanket, the parents said that they didn’t have enough hats that fit (their baby is super cute but very tiny) so I decided to make a Greenleaf Baby Hat from the left over yarn (found via Ravelry pattern suggestions which worked very well). I’ll post up about it in more detail later, but until then here’s a photo of the finished article:

DSCF5452I’m going to try very hard to avoid another hiatus. It might be that every couple of days or so I just post up a quick photo and a short line of what’s been going on since I last posted or during the 2 month(!) hiatus. We’ll see.

The seed of a sprout

Not gardening, but the start of a Sprout blanket! I’m hoping to turn the below pile into one over the next few weeks. Cheers to Knittin’ in Britain for the idea!

DSCF5177

The original pattern calls for Spud & Chloe Sweater yarn in the Grass colourway. However, this being an American luxury(ish) yarn, trying to get enough here in the UK to make a blanket in would set me back £33. So I’m using Paton’s Cotton Twist in Lime instead, bought from Pack Lane Wool at a much more reasonable £10.92 for 6 balls (plus one extra they sent me by accident, yay! I did offer to return it but they declined).

I really shouldn’t start anything new given the number of WIPs I have sitting around, but I think I need something to kick start me back into knitting and crocheting again. That’s my excuse anyway and I’m sticking to it. ;) This WIP really wants me to finish it though, just look at its poor, forlorn eyes…

DSCF5182

You can’t keep a good amaryllis down

Except that’s misleading, as wikipedia tells me they’re actually called “hippeastrum” (despite being commonly known as “amaryllis”). Anyway, I digress.

I bought an amaryllis bulb from ASDA some time in December, costing the princely sum of £3, and it came in a sealed box. I had good intentions of planting it up before Christmas but it sat in the kitchen, forlorn and forgotten (doesn’t this sound similar to the rhubarb story? My kitchen is obviously some sort of plant limbo.). About a fortnight ago I glanced at the worktop and saw this:

DSCF4952

It had decided not to wait for me and started growing. Out of the box, it looked a little anaemic but otherwise ok.

DSCF4954

Fortunately there was a bit of space on my incredibly crowded windowsills for it. If anyone’s interested, the blue tin bucket is also an ASDA purchase, and also for £3. I must say I found that one so charming I bought a second (although there isn’t space for it on the windowsill yet!).

DSCF4956

Since then it’s greened up a lot and got even taller:

DSCF5120

Here’s hoping for some stunning flowers soon! Hope everyone had a good Easter weekend. MIne was incredibly busy and rather expensive, but I’ll post about that later. :)